Featured
- Get link
- X
- Other Apps
Backwashing Intex Pool Filter
Backwashing Intex Pool Filter. Backwashing is a filter cleaning process through your filter system that reverses the flow of water. Select the “backwash” position on your multiport valve handle.

How often to backwash pool. Switch valve to “backwash” setting. The best solution here would be to start by backwashing your intex sand filter.
Turn The Pool Filter System Off.
In a unit like this, the. Set the multiport to backwash, and connect the drain hose. Again, the “backwash” setting will reverse the direction of the pool.
The Water Goes In Whichever Direction The Valve Points.
Prepare a chemical bath for your filter in a container large enough to hold the entire pool filter. Switch off the pump motor before you start backwashing to prevent new pool water from entering the tank. So here are the parts i used.
To Make Your Solution, Combine 1 Cup Of Trisodium Phosphate (Tsp) And 4 Cups Of.
It uses a normal operating filter pressure to clean. Vacuum to waste does the same as far as your level. Check out the electrical fire i had on the pump:
Select The “Backwash” Position On Your Multiport Valve Handle.
Don't be afraid to ask questions, or leave comments. After turning off the pump, change the valve’s setting to “backwash.”. Backwashing will keep the filter clean and prevent clogging for a longer.
If Your Pool Has A Sand Filter, It Goes Without Saying That The Sand Should.
Backwash your pool sand filter when the pressure reading is around 10 psi higher than the normal psi. Cantex adapter, 90 deg elbow, and a short piece of 1 1/4 pvc to connect it together. Turning on the pool pump will push the water into the filter and through the multiport valve.
Popular Posts
Content Based And Collaborative Filtering Hybrid
- Get link
- X
- Other Apps
Comments
Post a Comment