Pur Filter Model Crf-950Z . Fits pur water coolers and water bottles. Life span of two months or 40 gallons. PUR NEW WATER FILTRATION SYSTEM 3 PITCHER REFILL FILTERS MODEL CRF from www.pinterest.com For best performance, replace with a genuine pur filter when change light turns red. Remember to replace your genuine pur pitcher filters every 2 months or 40. Fits pur water coolers and water bottles.
How To Clean Out A Sand Filter. If the pool pump is on, switch it off and make sure the filter valve is set to the “filter” position. 2) turn off the pool pump.
How To Vacuum Your Pool With A Sand Filter Cleaning Pool Filter from www.waterev.com
Use a small cup to remove the sand a little by little until the sand filter is light enough to be picked up and dumped out. Run the pump again until the sight glass is clear. Then close the wet harrow drain and open the output pipe and restart the filter.
Be Mindful To Not Damage The Air Relief Tube Or Laterals At The Bottom Of The Filter.
Use a small cup to remove the sand a little by little until the sand filter is light enough to be picked up and dumped out. Select the “backwash” position on your multiport valve handle. If all the dirt and oil has had time to settle.
After Wet Harrowing, Let Water Run Through The.
This will create a link between the garden hose and the sound filter. Turn the valve handle to “rinse”. If there is a valve in front of the pump, make sure it is closed.
Pour Sand Filter Cleaner Into The Strainer Basket And Replace The Lid.
Switch off the pool’s pump again. Turn the pump on for long enough to transfer the cleaner from the pump to the filter (roughly 15 seconds). Attach your pool hose to the backwash port on your sand filter.
Run The Pump For A Couple Of Minutes To Flush Out Fine Sand Particles.
Turn off the vacuum and come back valve on. Now turn the pump back off and turn the handle to “rinse”. After all, the last thing you want now is to gradually flush the algae back into the pool.
2) Turn Off The Pool Pump.
If the pool pump is on, switch it off and make sure the filter valve is set to the “filter” position. Next, remove the filter cartridge and wash it thoroughly. Open up the filter so the sand bed is exposed.
Comments
Post a Comment